STR | SocalTrailRiders.org

Neccros · 08-17-2007, 06:43 PM

Anyone here know a good quick set up for a Talas RLC?? first ride on it is tomorrow and I wanna dial it in somewhat before then....

I got the pressure setup but there is the slow speed compression, etc that Im not sure whats a good base setting

thanks

CalEpic · 08-17-2007, 09:48 PM

On that fork I ran the rebound about 4 clicks from full fast and the compression 3-4 from full soft. The compression was the trickiest for me. Set it soft and it's nice and plush but brake dived too much. It's a compromise.

C

08-17-2007, 06:43 PM	#1 (permalink)
Neccros Technically Canadian	Fork setup Anyone here know a good quick set up for a Talas RLC?? first ride on it is tomorrow and I wanna dial it in somewhat before then.... I got the pressure setup but there is the slow speed compression, etc that Im not sure whats a good base setting thanks __________________ My pedals don't stick!!!!!!!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Hayes 9 bleed port plug fitment and questions	Flat Broke	The Workshop	0	08-01-2007 09:30 PM
Avid Juicy 5	Jordansrealm	The Workshop	13	07-31-2007 11:41 AM
Tips: Avid Juicy 5 Pads	Jordansrealm	The Workshop	10	06-08-2007 07:38 PM
Juicy 5 Question	Rossage	The Workshop	4	05-21-2007 07:42 PM
HELP: I need a good, low-budget light setup...ideas???	L8 APEKS	General Discussion	6	10-07-2005 12:37 AM

08-17-2007, 09:48 PM	#2 (permalink)
CalEpic STR Moderator	On that fork I ran the rebound about 4 clicks from full fast and the compression 3-4 from full soft. The compression was the trickiest for me. Set it soft and it's nice and plush but brake dived too much. It's a compromise. C

STR | SocalTrailRiders.org

Your Southern CaliforniaMountain Biking Community

Your Southern California
Mountain Biking Community