Easton Havoc Bolt-on axle

[TCB]

Just wanted to pass along some news, Easton just started making a Bolt-on axle for the Havoc rear Hub, I have been using the Bolt-on axle for about a Month and it’s a noticeable improvement, much stiffer from the old QR

Here are a few photos.

[bobzrag]

looks good, where'd you get it, how much?

[Tedroy]

At least its on a proper bike!

[TCB]

Originally Posted by bobzrag

looks good, where'd you get it, how much?

Easton sent me the kit to demo.
I believe the Bolt-on axle kit will be about $80, that will include the bearings for the drive and non drive side, Bolt-on Axle and Tools needed for installation.
Installation was vary easy, it only took me about two hours to install.

[sdyeti]

Thanks...I have the Havocs and this could be an upgrade if I want to start hitting bigger stuff...

[Nagaredama]

Originally Posted by TCB

Installation was vary easy, it only took me about two hours to install.

Two hours, it couldn't have been that easy.

Havoc's are nice wheels but $80 for a bolt-on axle? What does it cost to convert Hope hubs to bolt-on?

[TCB]

Originally Posted by Nagaredama

Two hours, it couldn't have been that easy.

Havoc's are nice wheels but $80 for a bolt-on axle? What does it cost to convert Hope hubs to bolt-on?

Here is the full breakdown of cost

Drive Side Bearing $3.33

Non Drive Side Bearing $2.46

Tools needed for install $34.16

Axle with endcaps and bolts $42.00

TOTAL 81.95