STR | SocalTrailRiders.org
Your Southern California
Mountain Biking Community
|
|||||||
| General Discussion For any bike discussion that doesn't belong in other forums. |
|
|
Thread Tools |
|
DAN THE MAN
|
i can see that DH/FR tubes are thicker and obviously that makes them heavier than regular or lighter tubes.. but if i dont race and just ride for pure pleasure, will it make that much of a difference?
oops- just think i found my answer- DH/FR are bigger and will only fit DH/FR wheel/tire setups?... yay me.
__________________
FoShizzle: lactic acid is ghey. if you dont ride you will not have issues with it |
|
Stop stealing my thunder!
|
In a word, yes. Thicker tubes will be heavier, obviously. This means it will be harder to pedal so you will tire more easily. It is rotating mass, at the very outermost edge at that, which means this is where you will notice weight the most. You will get less traction for the same given air pressure since the thicker tubes resist tire deformation more than a regular tube. On the positive note, you will be less likely to get a flat of any type with a DH tube than with a regular tube.
Hope this helps. Duc
__________________
"To take yourself too seriously is foolish. To take what I say seriously is just plain stupid!" - Wise Vietnamese man |
| post thanked by: |
capnsavem (01-30-2008)
|
![]() |
|
|
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 26" tube on your 29" wheel? | station | Trail Talk | 9 | 01-20-2008 08:57 PM |
| Sizing and head tube angle help please | dirtmistress | General Discussion | 11 | 12-11-2007 07:44 AM |
| Frame sizing question... | Jman | The Workshop | 9 | 11-25-2007 06:35 PM |
| Rear hub question... | gurp13 | The Workshop | 21 | 11-12-2007 08:49 AM |
| inner tube slippage | gurp13 | The Workshop | 17 | 09-18-2006 08:44 PM |




